Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
facilities:fablab:software:prusaslicer [2019/06/14 18:02] Michael Byrne |
facilities:fablab:software:prusaslicer [2019/06/14 18:09] Michael Byrne |
||
---|---|---|---|
Line 10: | Line 10: | ||
==== ==== | ==== ==== | ||
- | | ^ | + | |^ |
| 4 | Use **Move**, | | 4 | Use **Move**, | ||
| 5 | Select a **Quality / Speed** setting for your print {{: | | 5 | Select a **Quality / Speed** setting for your print {{: | ||
| 6 | Material selection {{: | | 6 | Material selection {{: | ||
- | | 7 | Select a **Supports** setting {{: | + | | 7 | Select a **Supports** setting {{: |
+ | ==== ==== | ||
- | | ^ ^ | + | |^ ^ |
| 8 | Select an **Infill** percentage {{: | | 8 | Select an **Infill** percentage {{: | ||
- | | 9 | Click **Slice**{{: | + | | 9 | Click **Slice**{{: |
+ | ==== ==== | ||
+ | |||
+ | |^ | ||
| 10 | {{: | | 10 | {{: | ||
| 11 | Generate and export //gcode// to the SD Card by clicking the **Export G-Code** button {{: | | 11 | Generate and export //gcode// to the SD Card by clicking the **Export G-Code** button {{: |