Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
facilities:fablab:software:vcarve:start [2019/09/04 14:41]
Andrei Maberley
facilities:fablab:software:vcarve:start [2019/09/04 14:44] (current)
Andrei Maberley
Line 91: Line 91:
 ===== Using VCarve Makerspace Client Edition ===== ===== Using VCarve Makerspace Client Edition =====
  
-Then open the about menu and enter The Edge Makerspace ID. +It is imported to use The Edge makerspace ID - otherwise your designs will not open on the Fabrication Lab machines! To do this open the about menu
  
-  ​86B4F-F467A-280D9-9F4C6-9C56B-4C528-BEE6F ​+{{ :​facilities:​fablab:​software:​vcarve:​vcarve_trial.png?​400 |}} 
 + 
 + And enter The Edge Makerspace ID.  
 + 
 + 86B4F-F467A-280D9-9F4C6-9C56B-4C528-BEE6F ​
  
 You will then have to close and relaunch VCarve. You will then have to close and relaunch VCarve.
  
-{{ :​facilities:​fablab:​software:​vcarve:​vcarve_trial.png?​400 |}}+
  
 ==== ==== ==== ====
  • facilities/fablab/software/vcarve/start.txt
  • Last modified: 2019/09/04 14:44
  • by Andrei Maberley