Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
facilities:fablab:software:vcarve:start [2019/09/04 14:41] Andrei Maberley |
facilities:fablab:software:vcarve:start [2019/09/04 14:44] Andrei Maberley |
||
|---|---|---|---|
| Line 91: | Line 91: | ||
| ===== Using VCarve Makerspace Client Edition ===== | ===== Using VCarve Makerspace Client Edition ===== | ||
| - | Then open the about menu and enter The Edge Makerspace ID. | + | It is imported to use The Edge makerspace ID - otherwise your designs will not open on the Fabrication Lab machines! To do this open the about menu |
| - | | + | {{ : |
| + | |||
| + | And enter The Edge Makerspace ID. | ||
| + | |||
| + | 86B4F-F467A-280D9-9F4C6-9C56B-4C528-BEE6F | ||
| You will then have to close and relaunch VCarve. | You will then have to close and relaunch VCarve. | ||
| - | {{ : | + | |
| ==== ==== | ==== ==== | ||
