Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
facilities:fablab:software:prusaslicer [2019/06/14 18:09] Michael Byrne |
facilities:fablab:software:prusaslicer [2023/04/28 16:13] (current) Steven Curran |
||
---|---|---|---|
Line 5: | Line 5: | ||
| ^ ^ | | ^ ^ | ||
- | | 1 | Open the **PrusaSlicer** | + | | 1 | Open the **PrusaSlicer** |
- | | 2 | Use the **Add** {{: | + | | 2 | Use the **Add** |
| 3 | **Delete** {{: | | 3 | **Delete** {{: | ||
+ | |||
==== ==== | ==== ==== | ||
Line 14: | Line 15: | ||
| 5 | Select a **Quality / Speed** setting for your print {{: | | 5 | Select a **Quality / Speed** setting for your print {{: | ||
- | | 6 | Material selection {{: | + | | 6 | Material selection |
| 7 | Select a **Supports** setting {{: | | 7 | Select a **Supports** setting {{: | ||
==== ==== | ==== ==== | ||
Line 24: | Line 25: | ||
|^ | |^ | ||
- | | 10 | {{: | + | | 10 | {{: |
| 11 | Generate and export //gcode// to the SD Card by clicking the **Export G-Code** button {{: | | 11 | Generate and export //gcode// to the SD Card by clicking the **Export G-Code** button {{: | ||
==== ==== | ==== ==== |