Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
facilities:fablab:software:prusaslicer [2019/06/14 18:09]
Michael Byrne
facilities:fablab:software:prusaslicer [2019/06/14 18:11]
Michael Byrne
Line 24: Line 24:
  
 |^                                                                                                                                                                                                                                                                                                                                                                                               ​^ ​                           ​ |^                                                                                                                                                                                                                                                                                                                                                                                               ​^ ​                           ​
-|  10    | {{:​facilities:​fablab:​software:​sliced_info.png?​200}}\\ Check the **Sliced Info** for the cost and how long its going to take to print before exporting your gcode\\ //The Edge charges 15cents / gram and your print need to be finished before the Lab Closes - talk to the Fab Lab Supervisor if you have a long job you'd like to do .//                                                    |+|  10    | {{:​facilities:​fablab:​software:​sliced_info.png?​200}}\\ Check the **Sliced Info** for the cost and how long its going to take to print before exporting your gcode\\ //The Edge charges 15cents / gram and your print needs to be finished before the Lab Closes - talk to the Fab Lab Supervisor if you have a long job you'd like to do .//                                                    |
 |  11    | Generate and export //gcode// to the SD Card by clicking the **Export G-Code** button {{:​facilities:​fablab:​software:​screen_shot_2019-06-13_at_2.32.20_pm.png?​300}}. ​                                                                                                                                                                                                                          | |  11    | Generate and export //gcode// to the SD Card by clicking the **Export G-Code** button {{:​facilities:​fablab:​software:​screen_shot_2019-06-13_at_2.32.20_pm.png?​300}}. ​                                                                                                                                                                                                                          |
 ==== ==== ==== ====
facilities/fablab/software/prusaslicer.txt · Last modified: 2019/06/18 16:35 by Andrei Maberley
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

We acknowledge Aboriginal and Torres Strait Islander peoples and their continuing connection to land and as custodians of stories for millennia. We are inspired by this tradition in our work to share and preserve Queensland's memory for future generations.