Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
facilities:fablab:software:inkscape [2019/07/08 15:13]
Michelle Brown [Designing a Sticker]
facilities:fablab:software:inkscape [2019/07/08 15:14] (current)
Michelle Brown [Designing a Sticker]
Line 291: Line 291:
  
 {{:​facilities:​fablab:​software:​vinylcutterillustratorlayout.png?​400|}} {{:​facilities:​fablab:​software:​vinylcutterillustratorlayout.png?​400|}}
- 
-{{:​facilities:​fablab:​software:​vinylcutterplugin.png?​400|}} 
  
 We load our vinyl roll on to the bottom of the vinyl cutter where there is a plastic roll holder, we feed the vinyl colour side up into the cutter and align it to the side but also make sure our feed rollers (small rollers that feed the sheet through) are inside the white marks. If they aren't you may get an error that says bad position. We load our vinyl roll on to the bottom of the vinyl cutter where there is a plastic roll holder, we feed the vinyl colour side up into the cutter and align it to the side but also make sure our feed rollers (small rollers that feed the sheet through) are inside the white marks. If they aren't you may get an error that says bad position.
Line 306: Line 304:
 We can see on screen a preview of what our sticker will print like and once you are happy with it, hit the print button and away we go! We can see on screen a preview of what our sticker will print like and once you are happy with it, hit the print button and away we go!
  
 +{{:​facilities:​fablab:​software:​vinylcutterplugin.png?​400|}}
  
 ===== Where to go for more info ===== ===== Where to go for more info =====
  • facilities/fablab/software/inkscape.txt
  • Last modified: 2019/07/08 15:14
  • by Michelle Brown