Differences

This shows you the differences between two versions of the page.

--- facilities:fablab:software:fusion360 [2018/08/03 10:25]
Andrei Maberley [Installation]
+++ facilities:fablab:software:fusion360 [2018/08/03 10:59]
Andrei Maberley [Tips and Tricks]
@@ Line 1: / Line 1: @@
  ====== Fusion 360 ======
-Fusion 360 is and Autodesk product for CAD CAM.  It is free (as in beer) for students, educators and start-ups.
+[[https://www.autodesk.com/products/fusion-360/students-teachers-educators|Fusion 360]] is and Autodesk product for CAD CAM.  It is free (as in beer) for students, educators and start-ups.  Fusion360 is used by The Edge programming staff when parametric design is an important requirement of a delivery or engagement.  We use parametric design to re-use designs, mainly changing material dimensions (thickness), tooling and design scaling.
+==== ====
-For example of internal work done with fusion 360 check out
+For example of internal work done with fusion 360 check out.
   * [[facilities:fablab:fittings-custom:milkcrate_shelving|Milkcrate Shelving]]
@@ Line 22: / Line 23: @@
 ===== Tips and Tricks =====
 ==== Parametric Design ====
-The tips to successful parameter usage, that is avoiding the dreaded "Over Constrained" errors -
+The tips to successful parameter usage, that is avoiding the dreaded "Over Constrained" errors.
 ==== ====
-Try to make sure that your parameters are controlling only a single dimension at a time. For example - a rectangle that has a length, width is fine.  But if you add a curve with a radius that intersects both edges, and then dimension that curves radius... you could have a problem.  Because the radius limits how far apart the sides can be.
+Make sure that your parameters are controlling only a single dimension at a time. For example - a rectangle that has a length, width is fine.  But if you add a curve with a radius that intersects two edges, and then dimension that curves radius... you have a problem because the radius limits how far apart the sides can be.
+==== ===