Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
facilities:fablab:inductions:multicamcnc:start [2019/04/24 12:36] Michael Byrne |
facilities:fablab:inductions:multicamcnc:start [2019/04/27 12:50] pgullberg [Depth, Feeds, Plunge and Speeds] - Adjusted recommended cut depth offset |
||
---|---|---|---|
Line 218: | Line 218: | ||
Set the depth in the path dialogue. | Set the depth in the path dialogue. | ||
- | * Depth - How far **above** the bottom of the wastebed | + | * Depth - How far **above** the bottom of the waste board the router starts its cut. |
- | * we generally finishing | + | * Currently add an additional |
+ | * This may change after each service and/or waste board planing) | ||
+ | * If your material is 15mm thick (make sure to measure) then the cut depth should be 15.5mm | ||
==== Feeds, Plunge and Speeds ==== | ==== Feeds, Plunge and Speeds ==== |