Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
facilities:fablab:inductions:lasercutter:start [2019/10/02 17:10] Andrei Maberley [Check the focal distance] |
facilities:fablab:inductions:lasercutter:start [2019/10/02 17:30] Andrei Maberley [Check the focal distance] |
||
---|---|---|---|
Line 96: | Line 96: | ||
- | ===== ===== | + | ===== Raise the bed... Carefully... |
- | + | ||
- | Raise the bed... Carefully... | + | |
10.jpg | 10.jpg | ||
+ | |||
11.jpg | 11.jpg | ||
+ | |||
+ | ==== ==== | ||
As the bed approaches the head, use individual button clicks to move the bed up until it JUST touches the focus device, either knocking it off or causing it to move. | As the bed approaches the head, use individual button clicks to move the bed up until it JUST touches the focus device, either knocking it off or causing it to move. | ||
- | ==== ==== | + | ===== Put it back where it lives! |
- | + | ||
- | Put it back where it lives! | + | |
Line 118: | Line 117: | ||
- | ===== ===== | + | =====Position the laser===== |
- | + | ||
- | Position the laser | + | |
Line 129: | Line 126: | ||
- | ===== ===== | + | =====Shut the lid ==== |
- | Shut the lid | + | |
15.jpg | 15.jpg | ||
Line 137: | Line 132: | ||
- | ===== ===== | + | ===== Open Corel Draw ===== |
- | Open Corel Draw | + | |
16.jpg | 16.jpg | ||
- | ===== ===== | + | ===== Corel Draw ===== |
- | Corel Draw | + | |
Line 163: | Line 156: | ||
- | ===== ===== | + | ===== Select File > ‘New from Template’ |
- | + | ||
- | Select File > ‘New from Template’ | + | |
18.jpg | 18.jpg | ||
- | ===== ===== | + | ===== Choose ‘edgetemplate.cdt’ Template |
- | + | ||
- | Choose ‘rayjet.cdt’ Template | + | |
19.jpg | 19.jpg |