Differences

This shows you the differences between two versions of the page.

--- facilities:fablab:inductions:lasercutter:start [2019/10/02 17:08]
Andrei Maberley [Position the laser head]
+++ facilities:fablab:inductions:lasercutter:start [2019/10/02 17:30]
Andrei Maberley [Check the focal distance]
@@ Line 80: / Line 80: @@
 {{ :facilities:fablab:inductions:lasercutter:image8.jpg?direct&400 |}}
-===== Check the focal distance  =====
+===== Check the focal distance =====
@@ Line 86: / Line 86: @@
 .jpg
 .jpg
   * Take the focus check
   * device and place
@@ Line 95: / Line 96: @@
-===== =====
+===== Raise the bed... Carefully... ====
-Raise the bed... Carefully...
 .jpg
 .jpg
-As the bed
-approaches the
-head, use individual
-button clicks to
-move the bed up
-until it JUST touches
-the focus device,
-either knocking it off
-or causing it to
-move.
+==== ====
-===== =====
+As the bed  approaches the head, use individual button clicks to move the bed up until it JUST touches the focus device, either knocking it off or causing it to move.
-Put it back where it lives!
+===== Put it back where it lives! =====
@@ Line 123: / Line 117: @@
-===== =====
+=====Position the laser=====
-Position the laser
@@ Line 133: / Line 126: @@
-===== =====
+=====Shut the lid ====
-Shut the lid
 .jpg
@@ Line 141: / Line 132: @@
-===== =====
+===== Open Corel Draw =====
-Open Corel Draw
 .jpg
-===== =====
+===== Corel Draw =====
-Corel Draw
@@ Line 167: / Line 156: @@
-===== =====
+===== Select File > ‘New from Template’ ====
-Select File > ‘New from Template’
 .jpg
-===== =====
+===== Choose ‘edgetemplate.cdt’ Template =====
-Choose ‘rayjet.cdt’ Template
 .jpg