Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
facilities:fablab:equipment-cots:hp_sprout_pro:start [2019/11/28 10:04] Andrei Maberley [SLAM Fusion Scanning] |
facilities:fablab:equipment-cots:hp_sprout_pro:start [2019/11/28 10:06] Andrei Maberley |
||
---|---|---|---|
Line 175: | Line 175: | ||
=====Before you start==== | =====Before you start==== | ||
- | Ask the Fabrication Lab Supervisor if the Sprout has been used today or recently calibrated. | + | * Ask the Fabrication Lab Supervisor if the Sprout has been used today or recently calibrated. |
- | + | | |
- | The sprout structured light scanning works best with some ambient (non-direct) lighting. Open up the sides (not the top) of the photobooth before you start to scan. | + | * Check with the Fabrication Lab supervisor whether the sprout has been used or calibrated recently. |
+ | * Turn on the Sprout. | ||
+ | * Log in as edgeuser (password edgeuser) | ||
+ | * Close up the sides of the photobooth (leave the front and the vent on the top open) | ||
+ | |||
====Preparation==== | ====Preparation==== |