Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
facilities:fablab:equipment-cots:hp_sprout_pro:start [2019/11/28 10:03] Andrei Maberley |
facilities:fablab:equipment-cots:hp_sprout_pro:start [2020/03/23 11:54] Andrei Maberley [Dark Objects] |
||
---|---|---|---|
Line 87: | Line 87: | ||
====Before you start==== | ====Before you start==== | ||
- | Check with the Fabrication Lab supervisor whether the sprout has been used or calibrated recently. | + | * Check with the Fabrication Lab supervisor whether the sprout has been used or calibrated recently. |
- | Turn on the Sprout. | + | |
- | Log in as edgeuser (password edgeuser) | + | |
- | Close up the sides of the photobooth (leave the front and the vent on the top open) | + | |
====Scanning - Prep==== | ====Scanning - Prep==== | ||
Line 175: | Line 175: | ||
=====Before you start==== | =====Before you start==== | ||
- | Ask the Fabrication Lab Supervisor if the Sprout has been used today or recently calibrated. | + | * Ask the Fabrication Lab Supervisor if the Sprout has been used today or recently calibrated. |
- | + | | |
- | The sprout structured light scanning works best with some ambient (non-direct) lighting. Open up the sides (not the top) of the photobooth before you start to scan. | + | * Check with the Fabrication Lab supervisor whether the sprout has been used or calibrated recently. |
+ | * Turn on the Sprout. | ||
+ | * Log in as edgeuser (password edgeuser) | ||
+ | * Close up the sides of the photobooth (leave the front and the vent on the top open) | ||
+ | |||
====Preparation==== | ====Preparation==== | ||
Line 183: | Line 187: | ||
- | =====Dark Objects===== | ||
Line 190: | Line 193: | ||
* For background the image is now too bright because the calibration panels are white - this cannot be helped ((a darker surface on the touch mat may help - ask the Fabrication Lab supervisor to assist)) | * For background the image is now too bright because the calibration panels are white - this cannot be helped ((a darker surface on the touch mat may help - ask the Fabrication Lab supervisor to assist)) | ||
+ | =====HP 3D Scan 5===== | ||
+ | Launch the HP 3D Scan app from the taskbar or desktop | ||
=====Waves in Scan===== | =====Waves in Scan===== | ||