Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
facilities:fablab:equipment-cots:hp_sprout_pro:start [2019/11/28 10:03] Andrei Maberley |
facilities:fablab:equipment-cots:hp_sprout_pro:start [2019/11/28 10:04] Andrei Maberley [SLAM Fusion Scanning] |
||
---|---|---|---|
Line 87: | Line 87: | ||
====Before you start==== | ====Before you start==== | ||
- | Check with the Fabrication Lab supervisor whether the sprout has been used or calibrated recently. | + | * Check with the Fabrication Lab supervisor whether the sprout has been used or calibrated recently. |
- | Turn on the Sprout. | + | |
- | Log in as edgeuser (password edgeuser) | + | |
- | Close up the sides of the photobooth (leave the front and the vent on the top open) | + | |
====Scanning - Prep==== | ====Scanning - Prep==== |