Search
You can find the results of your search below.
Fulltext results:
- Laser Cutter New Materials Testing Guide
- is to provide a guideline for the testing of the cutting and etching of new materials in the Edge’s <wrap ... rds and damage to equipment that could occur from cutting/ etching different materials in the Laser cutter.... f The Edge also reserves the right to the ban the cutting / etching of certain materials found to reduce th... contact the manufacturer and enquire about laser cutting of the material <wrap hi>**THE FOLLOWING MATER
- Machine Failure and Damage
- tion * Change training to allow origin (0x, 0Y) cutting only but users - 'move job to laser' is facilitat... Type II : Wrong Template or Document type === **Cutting from an template or document other than The Edge ... reported crack in the lens found after laser was cutting underpowered. ** New lens order** Michael from... near miss with the lense – it was so dirty after cutting a single sheet of masked 6mm ply that it took a g
- Workflow Options
- t or test </WRAP> <WRAP pagebreak></WRAP> ==== Cutting from Fusion 360 ==== **Why cut from Fusion360?**... s been extensively used to generate many DXFs for cutting without problems, using the recommended workflow. <WRAP pagebreak></WRAP> ==== Cutting from Autodesk ===== ===External Resources ==... {facilities:fablab:equipment-cots:cassworks-laser-cutting-guide-v2.3-.pdf|guide}} used by London Metropolit
- Rayjet 300 Laser Cutter
- aver.aspx)) is suitable for laser engraving and cutting of wood, plastics, leather, paper and many other ... mensions| 735mmx435, 6.5mm (material thickness)| |Cutting Materials| Plastics (acrylic, polypropylene, poly... vironment kit' fitted - meaning a more sealed in cutting area. *Speedy 300 uses JobControl - Rayjet 300
- Approval for Laser Materials
- wire) on 15/11/17 \\ Smoky but passed for laser cutting. Peter Musk **__Silicone Rubber 0.5mm__** Test ... rne. Silicon Rubber is a material recommended for cutting on the Trotec Website. After a few cuts we arri... following settings Etching 20% Power 4% Speed Cutting 40% Power 4% Speed {{page>:facilities:fablab:equ
- General Tips
- ==== Using lower DPI to speed up Engraving and Cutting ==== Another way to speed up engraving (and even cutting) is to lower the DPI in the print preferences. L
- Maintenance
- t ==== Daily Maintenance: CLOSE ==== * Remove cutting bed and clean debris from under bed. Wipe down wi
- ARCHIVED: Laser Settings
- **Engraving** ^ ^ ^ **Cutting** ^ ^ ^ ^
- Trotec Recommended Laser Material
- aterial ====== ===== Materials recommended for cutting/ etching on Trotec Rayjet Laser ===== | **Mater
- Active Carbon Absorption of Chemicals
- potentially toxic out-gasses caused by the laser cutting process, and is most critical to the operation of