Search
You can find the results of your search below.
Matching pagenames:
Fulltext results:
- Router Tooling, Feed Rates and Cutting Speeds
- DISCUSSION~~ =====Router Tooling, Feed Rates and Cutting Speeds===== ====Tool Geometry==== //You always w... lute | Single Flute cutters only have one cutting edge. These are good for faster feed rates in sof... | Double Flute | Double Flute cutter have cutting surfaces and are good for cutting harder materials at slower feed rates.
- Preflight checks - Vcarve
- Vcarve===== Before Exporting the NC file for your cutting program from VCarve check the following: * ... ns of the //plate// with the material you will be cutting? Especially the thickness - underestimating the t... s - Continued==== * Have you selected the right cutting tool for the job - cut diameter, cut depth, corre... eds recommended for the tool and material you are cutting? ====Preflight checks before exporting NC Files
- CNC Router Operations
- pment-cots:multicam_m-2412:tooling_feed_rates_and_cutting_speeds|Tooling, Feed Rates and Cutting Speeds]] * [[facilities:fablab:equipment-cots:multicam_m-2412:pre... :what_to_watch_for|What to watch for When you are cutting your job]] * [[facilities:fablab:equipment-cots... pment-cots:multicam_m-2412:tooling_feed_rates_and_cutting_speeds}} ==== ==== {{page>facilities:fablab:equip
- Supervisor Preflight Check
- physically ready to use ==== * An appropriate cutting tool has been selected for the job * The cutting tool is correctly fitted on the machine * The materi... propriate for the material being machined and the cutting tool being used. * Depth settings hare appropri
- Machine Safety
- eep clear of any rotating or moving parts eg. the cutting bit, spindle moving gantry and head parts. * Do... eration. * Parts of the machine , particularly cutting bits, will get hot so you may need gloves when ha... he spindle spins at up to 18,000 rpm - capable of cutting at over 10 metres/minute (m/m) * through meta
- Tangential Knife Operations
- Select specific knife blade appropriate for your cutting requirements. - The knife cutting length should be as close as possible to the thickness of material - Aga
- Preflight checks - getting the Machine ready to cut
- secure on the bed? * Have you loaded the right cutting file ( Preview File on the A2MC console)? **Check with the Fabrication Lab Supervisor before cutting** <WRAP hideslide> <WRAP center round box
- CNC Tooling @facilities:fablab:equipment-cots:multicam_m-2412:tooling
- Enables you to cut thicker materials * Maximum cutting depth: 1/4 in. (6.3mm) * Minimum cut radius in ... and foam Can be used with a 28mm Olfa (TM) or Fiskars (TM) rotary cutting wheel Tool Offset (20.3mm)
- Cutting with the Router
- ==== Cutting with the Router ===== * **Don PPE** * turn on bed suction * Turn extractor * start t
- CNC Safety
- ided and **Must** be worn whenever the Machine is cutting. Gloves are provided for the manual handling mat
- Multicam Commissioning
- we approach selling these materials, consumables (cutting tools)? * What are the various task required in
- Multicam M-2412
- ed version of the handheld router. It is used for cutting and hollowing shapes in hard materials - timber,
- Daily Setup
- ary ==== Setup Machine ==== * If there is a cutting tool/bit on the machine - ensure it is secure.
- CNC Research
- ssential to catching errors in programming before cutting * machine bed will need re-surfacing or replace
- Tool Change
- e ground) * Pair the right sized collet for the cutting Tool you have selected * Blow collet out clean